Care
After the ride
The routine to follow after every session: power down, rinse, dry, inspect and recharge.
Awake boards, Flex batteries, drive units and hand controllers.
Open guideAWAKE AU/NZ support
Owner guides
Step-by-step setup, charging and care for your AWAKE equipment.
8 guides
Power
Charge the battery
How to charge a Flex battery on its charger and know when it is full.
Flex batteries with the matching Awake charger shown. If your battery or charger differs, follow its supplied manual.
Open guideSetup
Set up RÄVIK 3 / RÄVIK S
Fit the fins, install the battery and pair the controller on a RÄVIK 3 or RÄVIK S.
RÄVIK 3 and RÄVIK S only. Not a setup guide for current RÄVIK models with XR4 batteries, or BRABUS.
Open guideSetup
Set up VINGA 3 / VINGA S
Fit the wings and shims, attach the board with Click-to-Ride, then install the battery on a VINGA 3 or VINGA S.
VINGA 3 and VINGA S with Powder (1800/1400) or Fluid (1300/1000) wings. Not verified for VINGA Carve or CLOUD wings.
Open guidePower
Charge the hand controller
Seat the wireless controller on its charger and watch progress on its screen.
The wireless hand controller and dock-style charger shown. Other controllers follow their supplied manual.
Open guidePower
Check battery charge
Three ways to see how much charge you have: battery lights, controller screen and the Awake Link app.
Flex batteries with the five-light LED panel, the wireless hand controller and the Awake Link app shown.
Open guideApp
Awake Link app
Install the app, connect a battery and find status, firmware and support.
Awake batteries and controllers that connect to Awake Link. Features vary by hardware and firmware.
Open guideCare
Storage and winterisation
Preparing your gear for a break of more than two months.
Awake boards, drive units and Flex batteries. Battery storage charge depends on your exact battery and manual.
Open guide